Page 214 - Techniks Catalog 2017

Large Head Mounting Instructions

Finish Heads

#20 Set Clamp Screws

#19 Slide Block Screws

Rough Heads

#4 Shield Lock Screws

#17 Set Clamp Screws

#16 Slide Block Screw

1. Loosen slide block screws (#19 finish heads, #16 rough heads).
2. Remove set clamp screws (#20 finish heads, #17 rough heads).
3. On finish boring heads only, remove shield lock screws #4.
4. Move slide blocks / shield off-center until the four counter bored bolt holes located in the body below
the slide blocks are completely exposed.
5. Place taper shank holder or adapter on back side of boring head with pilot completely engaged
in pilot cavity.
6. Insert 4 socket head cap screws into counter bored holes and tighten to 90 ft-lbs torque.

7. Push slide blocks back into position to line up with threaded holes below.
8. Insert nut / close shield lock screws and tighten.

9. Adjust boring head to desired diameter and tighten slide block lock screws.

212 Call 800.597.3921 or 317.803.8000 for a fast friendly quote. • Fax: 317.803.8001