Page 400 - Ceratizit Catalog
P. 400
MaxiMill 273 system
B73
Assembly procedures
1. Mount the setting wedges in the cutter (as supplied) and
Precision setting procedure tighten the setting screw (1), to lightly hold the wedge
without deforming it.
2. Mount inserts and tighten clamping screws (2) with
1.0 Nm.
3. Mark 'highest cutting edge' using a presetting device.
4. Change position of PCD insert by 0.02 mm turning the
setting screw (1) clockwise.
For this purpose use the TORX key (8095018900 /
WS-L-T15-136mm).
5. Set the other cutting edges to this level, maximum
deviation of 0.005 mm.
Maximum adjustment = 0.10 mm.
6. Tighten all clamping screws (2) with 4.0 Nm (273-06).
7. Check axial run-out of all inserts
→ target < 0.005 mm.
When changing the insert, first remove the setting screw (1), turning
it counter-clockwise. After the mounting procedure is completed, the
setting procedure starts again at point 1.
Milling / Face milling
