Page 849 - Ceratizit Catalog

Application advice
C244
GX system

Application advice for axial grooving and face turning

3 3 2
2
1 1
1 1
2
3 3 2
1 2 1 2 1 2
3 3 2
2
1 1
1 1
2
3 3 2
1 Minimum grooving diameter
2 Maximum grooving diameter

Axial grooving Axial grooving - groove Axial grooving and face
widening turning
is only possible within the diameter
range for that module (e.g. 50 - 70 mm). Groove widening is possible When face turning it is possible to widen
above and below the diameter the groove above and below the diam-
Please note: the indicated diameter range indicated on the module. eter range indicated on the module.
range refers to the outside diameter of
the groove. Please note: only the first groove must Please note: only the first groove must
lie within the diameter range of the mod- lie within the diameter range of the
ule. The depth of the widening groove module.
must not be larger than the depth of the
original groove.

Axial grooving and face turning

a max

Designation f [mm/rev] a max [mm] f [mm/rev]
GX24-2E3.00N0.30 0,05 - 0,15 2,5 0,05 - 0,20
GX24-3E4.00N0.40 0,05 - 0,15 3,0 0,05 - 0,25
GX24-3E5.00N0.40 0,05 - 0,15 3,0 0,10 - 0,25
GX24-4E6.00N0.50 0,05 - 0,20 3,5 0,10 - 0,30
GX24-2E3.00N0.30-F2 0,025 - 0,125 2,5 0,05 - 0,15 Parting and grooving / Technical information
GX24-2E3.50N0.30-F2 0,025 - 0,125 2,5 0,05 - 0,15
GX24-3E4.00N0.40-F2 0,05 - 0,15 3,0 0,10 - 0,20
GX24-3E4.50N0.40-F2 0,05 - 0,15 3,0 0,10 - 0,20
GX24-3E5.00N0.40-F2 0,075 - 0,20 3,5 0,10 - 0,20
GX24-4E6.00N0.50-F2 0,05 - 0,15 4,0 0,10 - 0,25