Page 245 - Techniks Catalog 2017

MagVISE Induction Blocks & Subplates For EEPM

Induction Blocks & Subplates Round Fixed &

We recommend using induction Spring-loaded Blocks
blocks or subplates at all times to pre-
serve the precision ground finish and
prevent damage to the face of the
magnetic chuck. Order subplates from EEPM-SP spring blocks adjust to hold warped stock.
the table on page 242. Example: machined
solid blocks to
Individual Induction Blocks hold round
stock.
Use induction blocks to raise the work-
piece above the surface of the mag-
net and permit machining 5 sides and EEPM-PS40
thru-hole drilling. Individual induction workstop
blocks provide maximum flexibility for
creating custom setups for holding dif- spring type
ficult workpieces and warped stock.
solid type
Part No. Description L W H
EEPM-SP spring loaded (2 piece set, 8mm screw) 1.89" 1.89" 1.41" Holding Warped Material
EEPM-SPF solid, machinable (8mm screw) 1.97" 1.97" 1.23"
Workpiece
Workpiece
Connected Induction Blocks Angled Induction Blocks & Workstop
Makes setups faster Use EEPM-SPF induction blocks on
and easier when the corners and EEPM-SP spring
large numbers of loaded blocks everywhere else
induction blocks are so the induction blocks adjust to
required. Choose match the warped stock.
from 2, 3, 4, or 6 pole
configurations.
Part Nesting Techniques

workstop
Part No. Desc.
Part No. Desc. L W H EEPM-IBT30 30˚ angle, 4-pole induction block

EEPM-IB225 2-pole block 4" 1.97" .98" EEPM-IBT45 45˚ angle, 4-pole induction block
EEPM-IB325 3-pole block 6" 1.97" .98" EEPM-IBT60 60˚ angle, 4-pole induction block
EEPM-IB425 4-pole block 8" 1.97" .98" EEPM-IBT90 90˚ angle, 4-pole induction block
EEPM-IB625 6-pole block 12" 1.97" .98" EEPM-PS40 round workstop (replacement)
Setup Notes For machining small, thin, or irreg-
Always make sure you read, understand and follow all the Owner’s Manual ular parts that do not have much
instructions and CAUTIONS that come with your EEPM Magnetic Chuck be- metal to attract the magnet, you
fore setting it up and using it. can create a shallow nest, or pock-
After installing your induction blocks we recommend cleanup milling the et in a subplate or induction blocks
surface of your induction blocks before loading your work piece to insure to secure the part and prevent lat-
that the surface height is uniform and parallel to the spindle. Subplates are eral movement. For part nests that
precision ground and do not require cleanup milling. you will use over-and-over again
Please note that the spring loaded induction blocks are NOT machineable, on repeat jobs use subplates to
but the solid blocks are able to be drilled and machined as required. save setup time.

We stand behind all our products with our 100% Satisfaction Guarantee • www.techniksusa.com 243