Page 839 - Ceratizit Catalog
P. 839

Types of wear
                                                                                                                   C234





                                                             Plastic deformation


                                                             Reasons
                                                             ○ Too high machining temperature resulting in softening of
                                                               substrate
                                                             ○ Wear / heat resistance of carbide grade too low
                                                             ○  Insufficient coolant supply

                                                             Remedies
                                                             ○  Reduce cutting speed
                                                             ○ Choose carbide grade with higher wear resistance
                                                             ○  Provide cooling


        High machining temperature and simultaneous mechanical stress may lead to
        plastic deformation.







                                                             Built-up edge

                                                             Reasons
                                                             ○ Cutting speed too low
                                                             ○ Rake angle too small
                                                             ○  Wrong cutting material
                                                             ○ Lack of cooling / lubrication

                                                             Remedies
                                                             ○ Increase cutting speed
                                                             ○ Enlarge rake angle
                                                             ○  Apply TiN-coating
                                                             ○ Use emulsion with higher concentration

        Built-up edge occurs when the chip is not evacuated properly due to insuffi-
        cient cutting temperature.







                                                             Notching

                                                             Reasons
                                                             ○  Oxidation of the cutting edge
                                                             ○ Excessive heat on the cutting edge

                                                             Remedies
                                                             ○ Use various depths of cut
                                                             ○ Reduce cutting speed
                                                             ○  Improve coolant supply





        Notch at the maximum depth of cut                                                                            Parting and grooving / Technical information
   834   835   836   837   838   839   840   841   842   843   844