Page 836 - Ceratizit Catalog
P. 836

Measures for parting and grooving problems
  C231






                             Type of problem

                  Type of wear      Work piece problems  Chip control














               Edge chipping  Built-up edge  Flank wear  Plastic deformation  Vibration  Formation of pips and burrs  Chattered surface  Surface quality  Chip too long (tangled swarf)  Chip too short (fragmented chip)  Corrective measures






                  ⇪        ⇪    ⇪    ⇧             ⇧       ⇧       Cutting speed

                        ≈       ⇧  ⇧            ⇪     ⇪  ⇪       ⇪  Feed rate                                   Cutting values
                ⇪
                                                                   Feed - centre area
                                                     ⇧
                                                ⇧
                                ⇧
                          ⇧
                                           ⇪
                ⇪
                                                                                                  -R
             ⇪ ⇪             ≈     ≈       ⇪    ⇪    ⇧     ⇪  ⇪    Chip groove                    -M
                                                                                                  -F
                                        ▢                          R / L - right-hand / left-hand
                                                                   version
                                                                                                 larger
             ⇪         ⇪ ⇪           ⇧     ⇪    ⇧  ⇧               Corner radius                                Selection of inserts

                                                                                                smaller
                                                                                             wear resistance
                       ⇪ ⇪                                         Cutting material

                ⇪
                                                                                               toughness
                                             ⇧ ⇧                   Cutting width
                                      ⇪
      Parting and grooving / Technical information
             ≈                     ≈          ≈    ≈               Clamping of tool

             ≈                     ≈          ≈    ≈               Clamping of work piece

             ≈                     ≈                 ⇧             Overhang                                     General criteria

             ≈          ≈          ≈    ≈          ≈               Tip height

                   ▢    ▢    ▢          ▢          ▢    ▢          Cooling lubricant

                  raise, increase,          avoid, reduce                               check,
             ⇪ large influence             ⇪  large influence                    ≈      optimise

                  raise, increase           avoid, reduce
             ⇧    low influence            ⇧  low influence                      ▢      use
   831   832   833   834   835   836   837   838   839   840   841