Roemheld CLRH-9-4581-0101 | 40mm Jaw Width Manual Vise

ROEMHELD MCP40 5-Axis Manual Vises

Fixed JawMechanical OperationThe MCP40 vise is extremely compact yet quite powerful. Like all of our 5-axis vises, this vise has optimal features to allow unrestricted tool access for multiple-side machining. The standard fixed-jaw design has one fixed jaw, and one moving jaw that clamps against it. 40mm wide x 110mm long, with 1700 lbs maximum clamping force. Made in Germany.The MCP series is a further refinement of our high-precision MC vise series. These new vises combine a very compact, fully enclosed design with a patented sliding-jaw segment design. Thanks to the adjusting spindle arranged in the upper part of the housing, deformation in the base during clamping is reduced to a minimum, providing high rigidity of the entire workholding system. The patented segment design ensures a high degree of precision and stability, reducing guiding clearance to nearly zero.

Application Information

Unique design allows clear tool access to five-out-of-six workpiece sides.

Mounting on a Quintus 1 Riser

Due to its small size, the MC40 vise must first be mounted on a Quintus Vise Adaptor Plate, which is then mounted on the Quintus 1 riser. To locate the vise on the adaptor plate, use two Fixture Locating Pins, a round pin for zero-point centering and a diamond pin for single-axis centering. To fasten the vise, use six M6 x 30mm socket-head cap screws inserted through the plate from below. Next, install a Quintus 1 pull-down bolt in the adaptor plate's M10 bottom center hole. To locate the adaptor plate, the Quintus 1 riser utilizes its two integral locating pins, a round pin for zero-point centering and a diamond pin for single-axis centering, which fit into the two 10mm locating holes underneath the plate. Turning the Quintus mechanism exerts 2700 lbs of force on the pull-down bolt.

Mounting on a Vise Adaptor Plate

To locate the vise, use two Fixture Locating Pins, a round pin for zero-point centering and a diamond pin for single-axis centering. To fasten the vise, use six M6 x 30mm socket-head cap screws inserted through the plate from below.

Material

Parts Specification

Warning:

This product can expose you to materials and/or chemicals including arsenic, lead, and other materials and/or chemicals which are known to the state of California to cause cancer and/or reproductive harm.

For more information, visit www.P65Warnings.ca.gov