Royal 25200 | 3 Pc Chuck Stop Standard Set

Chuck Stop Standard Set — includes 15, 20, & 25 mm stops

• The Royal Chuck Stop provides a simple, consistent method for locating short parts in a 3-jaw lathe chuck
• Captive, web-shaped design eliminates the danger of using spacers or parallels that could come loose and be thrown from a spinning chuck. Three strong magnets further secure the stop to the chuck face
• Stop allows short parts to project past the chuck jaws, providing clearance for facing operations
• Setup time is greatly reduced – no need to bore soft jaws
• The Royal Chuck Stop is very accurate – front and back locating surfaces are parallel within ± 0.0004"
• Accommodates chuck jaws up to 55mm (2 1/8") wide
• Anodized finish provides good wear-resistance

Warning:

This product can expose you to materials and/or chemicals including arsenic, lead, and other materials and/or chemicals which are known to the state of California to cause cancer and/or reproductive harm.

For more information, visit www.P65Warnings.ca.gov