Page 295 - Ceratizit Catalog
P. 295

Types of wear
                                                                                                                   A274





                                                             Flank wear


                                                             Reasons
                                                             ○ Cutting speed too high
                                                             ○  Carbide grade with insufficient wear resistance
                                                             ○ Incorrect feed rate
                                                             Remedies
                                                             ○  Reduce cutting speed
                                                             ○  Select more wear resistant carbide grade
                                                             ○ Adapt feed rate to cutting speed and cutting depth
                                                               (increase feed rate)


        Abrasion on flank, normal wear after a certain machining time.








                                                             Edge chipping

                                                             Reasons
                                                             ○ Grade with too high wear resistance
                                                             ○ Vibration
                                                             ○  Feed rate too high or excessive cutting depth
                                                             ○ Interrupted cut
                                                             ○ Swarf damage

                                                             Remedies
                                                             ○ Use tougher grade
                                                             ○  Use negative cutting edge geometry with chip groove
                                                             ○ Increase stability (tool, work piece)

        Through excessive mechanical stress at the cutting edge fracture and chipping
        can occur.







                                                             Cratering

                                                             Reasons
                                                             ○  Cutting speed and / or feed rate too high
                                                             ○ Rake angle too shallow
                                                             ○ Grade with low wear resistance
                                                             ○  Insufficient coolant supply
                                                             Remedies
                                                                                                                     Turning / Technical information
                                                             ○  Reduce cutting speed and / or feed rate
                                                             ○ Increase coolant quantity and / or pressure, optimise
                                                               coolant supply
                                                             ○  Use grade with higher resistance to cratering

        The hot chip which is being evacuated causes cratering at the rake face of the
        cutting edge.
   290   291   292   293   294   295   296   297   298   299   300