Page 297 - Ceratizit Catalog
P. 297

Corrective measures for turning problems
                                                                                                                   A276






                              Type of problem

                   Type of wear          Work piece problems  Chip control














           Flank wear  Cratering  Edge chipping  Plastic deformation  Insert breakage  Built-up edge  Vibration  Formation of pips and burrs  Chattered surface  Surface quality  Chip too long (tangled swarf)  Chip too short (fragmented chip)  Corrective measures




                                  ⇪        ⇧           ⇧       ⇧       Cutting speed
                            ⇪
                  ⇪
             ⇪
          ≈            ⇪   ⇧     ⇪      ⇧            ⇪    ⇪  ⇪       ⇪  Feed rate                            Cutting values

                                                                       Feed - centre area
                                                          ⇧
                                                     ⇧
                       ⇪
                                                ⇪
                  ⇪
                                                                                                -R
                   ⇪ ≈                ⇪  ≈      ⇪    ⇪    ⇧     ⇪  ⇪   Chip groove              -M
                                                                                                -F
                                                                                               larger

         ⇪         ⇪ ⇪                     ⇧    ⇪    ⇧  ⇧              Corner radius                         Selection of inserts

                                                                                               smaller
                                                                                            wear resistance

         ⇪ ⇪           ⇪  ⇪      ⇪                                     Cutting material

                                                                                              toughness
                    ≈         ≈         ≈          ≈ ≈                 Clamping of tool


                    ≈         ≈         ≈          ≈ ≈                 Clamping of work piece
                                                                                                             General criteria
                    ≈         ≈         ≈
                                                                       Overhang
                                                          ⇧
          ≈         ≈                   ≈ ≈             ≈              Tip height

          ▢ ≈            ▢         ▢         ▢          ▢ ▢            Cooling lubricant
                                                                                                                     Turning / Technical information




              raise, increase,                    avoid, reduce                         check,
                                                                                   ≈
         ⇪ large influence                        large influence                       optimise
                                                ⇪
              raise, increase                     avoid, reduce
         ⇧    low influence                     ⇧  low influence                  ▢     use
   292   293   294   295   296   297   298   299   300   301   302