Page 296 - Ceratizit Catalog
P. 296

Types of wear
   A275





                                                                Plastic deformation


                                                                Reasons
                                                                ○ Too high machining temperature, resulting in softening of
                                                                  substrate
                                                                ○ Damaged coatings
                                                                ○  Chip groove too narrow

                                                                Remedies
                                                                ○  Reduce cutting speed
                                                                ○ Choose carbide grade with higher wear resistance
                                                                ○  Provide cooling


           High machining temperature and simultaneous mechanical stress can lead to
           plastic deformation.







                                                                Built-up edge

                                                                Reasons
                                                                ○ Cutting speed too low
                                                                ○ Rake angle too small
                                                                ○  Wrong cutting material
                                                                ○ Lack of cooling / lubrication

                                                                Remedies
                                                                ○ Increase cutting speed
                                                                ○ Increase rake angle
                                                                ○  Apply TiN-coating
                                                                ○ Use emulsion with higher concentration

           Built-up edge occurs when the chip is not evacuated properly due to
           insufficient cutting temperature.







                                                                Insert breakage

                                                                Reasons
                                                                ○  Excessive stress of cutting material
                                                                ○ Lack of stability
                                                                ○ Corner angle too small
                                                                ○  Excessive notching
                                                                Remedies
      Turning / Technical information  Excessive stress of the insert causes breakage.   ○  Use more stable geometry
                                                                ○  Use tougher cutting material
                                                                ○ Use protective edge chamfer
                                                                ○ Increase honing of edge
   291   292   293   294   295   296   297   298   299   300   301