714.897.1700
Chat
Email
844.548.0100
Quotes
Quick Order
Features
- Unsurpassed Accuracy: Concentricity of ≤0.0001" (3µm) with tool shrunk in holder
- Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool
- Maximum Gripping Torque: Tool is gripped 360 degree along the entire length of bore producing very high gripping torque, preventing chatter
- Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds
- Balanced: GS follows the strictest balance standards. This holders are pre-balanced G2.5 up to 30,000 RPM
- Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS shrink fit toolholder should far outlast a standard end mill holder
- Chip load distributed evenly along cutting edge of tool which results in longer tool life
- Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending
- Since shrink fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market
Product Specifications
| Manufacturer Part Number | 546302 |
| Shank Type | Taper Shank |
| Taper Size | HSK63A |
| Hole Diameter (mm) | 4mm |
| Projection (mm) | 80mm |
| Nose Diameter (mm) | 15mm |
| Through Coolant | Yes |
| Product Type | Shrink-Fit Tool Holder |
Warning:
This product can expose you to materials and/or chemicals including arsenic, lead, and other materials and/or chemicals which are known to the state of California to cause cancer and/or reproductive harm.
For more information, visit www.P65Warnings.ca.gov
