Multi-Angle Slotted Locator Bushings
Slotted Locator Bushings can be used with many types of alignment pins and locating pins to align two holes without binding. The multi-angle version can be installed normally (0°) or at a 90° or 45° angle in the same mounting hole without machining a different pin location. Slotted Locator Bushings have a tight tolerance in one direction and full relief in the perpendicular direction. Made in USA.
Application Information
Multi-Angle Slotted Locator Bushings can be installed normally (0°) or at a 90° or 45° angle in the same mounting hole without machining a different pin location.
Installation
To install, first drill and ream the small hole for the roll pin, then bore the large bushing hole to provide .0003-0.0005" press fit. Press in the bushing and roll pin simultaneously for accurate orientation.
Material
Stainless Steel | |||||
Item | Material | Heat Treat | Finish | ||
Bushin | 440C Stainless Steel | Heat Treated | N/A | ||
Roll Pin | 300-Series Stainless Steel | - | N/A |
Parts Specification
Pin Diameter (Inch) | A | B Diameter (Inch) | C Diameter (Inch) | L (Inch) | M Diameter (Inch) | N (Inch) |
5/16" | 0.3126/0.3132 | 0.437" | 1.0000" | 0.40" | 3/16" | 3/8" |
Warning:
This product can expose you to materials and/or chemicals including arsenic, lead, and other materials and/or chemicals which are known to the state of California to cause cancer and/or reproductive harm.
For more information, visit www.P65Warnings.ca.gov