Unsurpassed Accuracy: Concentricity of โค0.0001" (3ยตm) with tool shrunk in holder
Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool
Maximum Gripping Torque: Tool is gripped 360 degree along the entire length of bore producing very high gripping torque, preventing chatter
Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds
Balanced: GS follows the strictest balance standards. This holders are pre-balanced G2.5 up to 30,000 RPM
Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS shrink fit toolholder should far outlast a standard end mill holder
Chip load distributed evenly along cutting edge of tool which results in longer tool life
Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending
Since shrink fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market
714.897.1700
Chat
Email
Quotes
Quick Order
